ADC Campus RS Destop Unit Manuel D’Utilisation
Installing and Configuring the Line Unit
Campus-RS Line Unit User Manual
May 29, 2002
13
S
ET
THE
HDSL O
PERATING
M
ODE
AND
T
RANSMISSION
R
ATE
This section provides generic instruction for setting the HDSL Operating
Mode and transmission rate. The actual steps depend on the interface card
mated with the Line Unit. Refer to the manual for the interface card for a
description of configuration options and complete configuration instructions.
Mode and transmission rate. The actual steps depend on the interface card
mated with the Line Unit. Refer to the manual for the interface card for a
description of configuration options and complete configuration instructions.
The steps in this section use the menu buttons and LCD on the Campus-Star’s
Campus Management Unit (CMU). To set the HDSL Transmission Rate:
Campus Management Unit (CMU). To set the HDSL Transmission Rate:
1
Use the Slot selection buttons to select the slot in which you installed the
Line Unit. The LCD displays:
Line Unit. The LCD displays:
MARGIN (LOC/RMT)
1:XX/XX 2:XX/XX
2
Press Escape four times to go to the top level menu.
3
Press Next until
HDSL LINK CONFIG & STATUS
displays, then press
Enter.
4
Continue with one of the following sections, depending on whether you
are using Standard Mode or Extended Mode.
are using Standard Mode or Extended Mode.
CMU-710 MANAGEMENT UNIT
SLOT
RESET
POWER
RS-232
ALARMS
MAJOR
MINOR
ACO
Menu buttons
Console port
Reset button
LCD display
Slot selection control pad
System alarm LEDs
NEXT
ENTER
ESC
1061.book Page 13 Wednesday, May 29, 2002 8:59 AM