ADC MLN7400 Manuel D’Utilisation
EVB7400
Chapter 2
Board Configuration
The EVB7400 is set with default configuration. You can use the board with the defualt settings direclty. However, you can also change
the settings according to your nedds.
2.1 Endian
Selection
(SW1)
Status
Description
BIG
LITTLE
BIG Endian
BIG
LITTLE
Little Endian
2.2 Boot ROM and ROM Bank0 length Selection (SW2)
Status
Description
X8
X16
ROM BANK0 Size is 8 bits.
ROM BANK0 : AT29C040 512 X 8bits Flash
ROM BANK2 : AM29LV160BB 1M X 16bits Flash
X8
X16
ROM BANK 0 size is 16 bits.
ROM BANK0 : AM29LV160BB 1M X 16 bits Flash
*Note : AT29C040(U9) should be removed
2.3 NAND
FLASH
You can use NAND Flash through GPIO of MLN7400. To use NAND Flash you shoud install 0 ohm registance.
Refer to schementic page4.
Install Register reference
Unintall Register Reference
R12, R13, R14, R15, R16,
R17, R18, R19, R20, R21,
R22, R23, R24, R25, R26
R22, R23, R24, R25, R26
R39, R40, R41,R42, R43,
R44, R54,R55,R56
*Note: To use NAND Flash, you can’t use SPI Interface, Console UART3 and High Speed UART(UART4)
User’s Manual V.0.10 11/36
Copyright © 2004 MCS LOGIC Limited. All rights reserved