Dixon Aficio 1515 Manuel D’Utilisation
Copying
20
2
Copying from the Bypass Tray
Use the bypass tray to copy onto OHP
transparencies, thick paper, enve-
lopes and copy paper that cannot be
loaded in the paper trays.
transparencies, thick paper, enve-
lopes and copy paper that cannot be
loaded in the paper trays.
Important
❒ Paper of 357 mm in length, or larg-
er, is likely to jam, crease, or not
feed in properly.
feed in properly.
Limitation
❒ You cannot use the duplex func-
tion when copying from the by-
pass tray.
pass tray.
Note
❒ If you do not use standard size
copy paper, or if you use special
paper, you should enter its vertical
and horizontal dimensions. See
p.17 “Placing Custom Size Origi-
nals”. The sizes you can enter are
as follows:
paper, you should enter its vertical
and horizontal dimensions. See
p.17 “Placing Custom Size Origi-
nals”. The sizes you can enter are
as follows:
❒ When copying onto OHP transpar-
encies or paper heavier than 105
g/m
g/m
2
(about 28 lb.), you need to
specify the paper type. See p.23
“When copying onto special pa-
per” .
“When copying onto special pa-
per” .
❒ The maximum number of sheets
you can load at the same time de-
pends on paper type. The maxi-
mum number of sheets should not
exceed the upper limit.
pends on paper type. The maxi-
mum number of sheets should not
exceed the upper limit.
AAAA
Open the bypass tray.
BBBB
Push up the paper guide release
lever.
lever.
1.
Paper guide release lever
Metric
version
version
• Vertical: 90–216 mm
• Horizontal: 139–600 mm
Inch
version
version
• Vertical: 3.55"–8.50"
• Horizontal: 5.48"–23.62”
ABU027S
StellaC2_GBcopy_F1_pre_FM.book Page 20 Tuesday, December 16, 2003 4:39 PM