D-Link DVG-2101S Manuel D’Utilisation

 
Setup 

 

DVG-2101S User Manual 

 

 

 

 

 

15

PPPoE 
Choose PPPoE (Point-to-Point Protocol over Ethernet) if your ISP uses a 
PPPoE connection. Your ISP will provide you with a username and password. 
Most DSL users will select this option. 
 

 

 

Enter the PPPoE user name supplied by your ISP. 

Enter the PPPoE password supplied by your ISP. 

Retype the password entered in the previous field. 

Enter the PPPoE Service Name (if supplied by your ISP). 

Set the specific period of time, in minutes, to disconnect from the 
ISP when no traffic is passing through. The setting 0 minute 
means the VoIP adapter will never disconnect from the ISP. 

Check this checkbox to allow the VoIP Adapter to re-establish the 
connection if it is terminated by the ISP. However, if the 
connection is terminated under any other conditions (i.e. by Idle 
Timeout or manual disconnect), the VoIP Adapter will not re-
establish the connection. This box is checked by default. 

Enter the MTU (Maximum Transmission Unit) size. MTU is the 
largest size packet that can be sent by the device. If the network 
stack of any packet is larger than the MTU value, then the packet 
will be fragmented before the transmission. During the PPP 
negotiation, the peer of the PPP connection will indicate its MTU 
and will accept any value up to that size.