D-Link DVG-2101S Manuel D’Utilisation

 
DVG-2101S User Manual 

 

Hardware Installation 

 

 

 

 

 

 

6 

 
Connecting the DVG-2101S Directly to a Modem 
If your computer connects directly to a DSL or Cable modem and does not 
connect to a router, follow the steps below to install your DVG-2101S. 
 
Note: This is the most common setup configuration for the DVG-2101S. If you 
do not require the use of more than one LAN port, you do not need an 
additional router. 

 

 
1.  Turn off your computer. 
2.  Disconnect the power to your Cable/DSL modem (unplug or turn off the 

power switch). 

3.  Unpack the Ethernet cable (blue) that comes with DVG-2101S. Attach one 

end of the Ethernet cable (blue) provided in this package to a LAN or 
Ethernet port on your Cable/DSL modem. If there are no Ethernet ports 
available on your modem, you should include a router in your network setup 
(see diagram on the next page). 

4.  Attach the other end of the provided Ethernet cable to the WAN port of the 

DVG-2101S. 

5.  Attach one end of the provided phone cable (gray) to a standard analog 

telephone. 

6.  Attach the other end of the phone cable to the PHONE port on the rear 

panel of the DVG-2101S. 

7.  Reconnect the power to the Cable/DSL Modem (plug in or turn on the power 

switch). 

8.  Unpack the 12V DC power adapter that comes with the DVG-2101S. 

Connect the power adapter to the power connecter on the DVG-2101S. 

9.  Connect the other end of the power adapter to an available electrical outlet 

(wall socket or surge protector). 

10. Restart your PC.