Emerson E2 Manuel D’Utilisation

The retrofit mounting plate and bracket allow the E2 to 

be mounted where previous generation controllers (Ein-
stein or REFLECS) were. These two options allow con-
version of the flush-mounted Einstein and the side-
mounted REFLECS.

Figure 3-5 shows the low-profile conversion mount 

plate that allows a flush-mounted Einstein to be converted 
to a low-profile mount. The plate slides over the back of 
the E2 and is attached using the four holes pictured closest 

to the cut out (four screws and four nuts are included), but 
the plate is equipped with a total of 14 holes for the best 
possible fit.

Figure 3-6 shows the conversion bracket that allows a 

side-mounted REFLECS to be converted to a side-
mounted E2. The conversion bracket is attached to the 
back of the E2 using the two holes at the top and bottom of 
the bracket, and aligning the oval openings with the oval 
cut-outs in the back of the E2 case. Once the E2 is attached 
to the conversion bracket, use the two holes in either side 
of the conversion bracket (depending on which side is 
needed) to mount the E2 to the wall and replace the 
REFLECS controller.