Emerson E2 Manuel D’Utilisation
Software Setup
E2 Ethernet Peer Communications
•
7
-
3
7.4.2
Open Network Layout
Figure 7-2
- Open Network Layout
7.5
Software Setup
1.
Log on to the E2 controller
2.
Navigate to the TCP/IP setup screen (Alt + T)
NOTE: DHCP does not have to be enabled if
you have the IP Address, Subnet Mask, and
Primary Gateway settings. (Contact your IT
you have the IP Address, Subnet Mask, and
Primary Gateway settings. (Contact your IT
Network Administrator for all IP configuration infor-
mation.) If you do not have the IP configuration set-
tings, and there is a DHCP server on the network, set
DHCP Enabled to Yes and it will retrieve the informa-
tion from the server and populate those fields. E2 con-
trollers must all have the same Ethernet Subnet in
order to communicate box-to-box.
mation.) If you do not have the IP configuration set-
tings, and there is a DHCP server on the network, set
DHCP Enabled to Yes and it will retrieve the informa-
tion from the server and populate those fields. E2 con-
trollers must all have the same Ethernet Subnet in
order to communicate box-to-box.
Figure 7-3
- TCP/IP Setup Screen
3.
Tab over to the Peer Netwrk tab:
Figure 7-4
- Peer Network Tab - Set Network Type
4.
Change Network Type to: Ethernet (ETH) and
press Enter. The Group Name field is now visi-
ble.
press Enter. The Group Name field is now visi-
ble.
NOTE: If unsure of any tab settings, it is rec-
ommended that the default settings be used.
ommended that the default settings be used.
5.
Once the Ethernet network type is enabled, enter
a unique site name in the Group Name field.
a unique site name in the Group Name field.
NOTE: The site name is the unique identifier
for the site that will allow the controllers
within the same group to share data.
for the site that will allow the controllers
within the same group to share data.