Braun HS 3 Manuel D’Utilisation

 

• Before each use check the gas level 

 

á

 

. To do so, remove the end cap 

 

8

 

. Change the energy cell when empty (see instructions).

• To aid ignition, hold the product upright. Turn on the gas flow by setting 

the switch 

 

2

 

 to the «1» position 

 

à

 

. 

 

â

 

• Pull the ignition switch back until you hear an audible «click» 

 

ä

 

. 

The on/ready indicator 

 

4

 

 will then light up, confirming that the heating 

system is on 

 

ã

 

.

• The appliance heats up fast and after approximately 90 seconds the on/

ready indicator will turn off: the appliance has reached the optimal 
styling temperature and is now ready for use.
A thermostat maintains the optimal styling temperature. The «ready» 
indicator may flash briefly during styling, whenever the appliance is 
heated up again to maintain a constant temperature.

 

• Turn off the Braun Independent Power Brush by moving the switch 

 

2

 

 to 

the «0» position and push the protective cover 

 

7

 

 on the appliance as far 

as it will go. The heat resistant protective cover can be placed on the 
brush, even if the product is still hot.

 

Make sure the appliance is switched off and cold.

For cleaning, remove the end cover  

 

6 

 

and pull off the comb lines 

 

å

 

. 

Immerse all removed parts in warm soapy water for a few minutes. Clean 
them with a brush, rinse and dry. After cleaning, push the comb lines 
back onto the Braun Independent Power Brush. To lock the comb lines, 
push back the cover 

 

ç

 

, first on the slit and then the opposite side against 

the direction of the arrow, until it locks

 

The handle 

 

1

 

 and the protective 

cover 

 

7

 

 may only be wiped with a soft damp cloth.

Never immerse the appliance in water.

Subject to change without notice.

This product conforms to the EMC-Requirements as laid down 
by the Council Directive 89/336/EEC

.

 

3585065.fm  Seite 4  Donnerstag, 2. August 2001  1:53 13