Boss Audio Systems GT-6 Manuel D’Utilisation
50
Chapter 5 Settings for Using the Expression and Control Pedals (Pedal Assign)
Target
fig.05-10
This sets the parameter to be affected. The parameters that
you can select as the target are shown below.
you can select as the target are shown below.
• Patch Level
• Patch Level Inc/Dec (how the level changes)
• Effect On/Off for each effect
• Effect parameters
• Master BPM (Tap input)
• Manual On/Off
• Tuner/Bypass On/Off
• Delay time (Tap input)
• MIDI Start/Stop
• MMC Start/Stop
* Although you can set this so that the same target is controlled
by more than one controller, in such cases, make sure not to
have different sources changing the parameter at the same
time. Changing the parameter simultaneously using different
sources may result in noise being generated.
have different sources changing the parameter at the same
time. Changing the parameter simultaneously using different
sources may result in noise being generated.
* The receiving device’s Sync Clock Mode must be set to
“Remote” when MIDI Start/Stop is selected as the target.
Target Range
fig.05-11
The value of the parameter selected as the target changes
within the range defined by “Min” and “Max,” as set on the
GT-6.
within the range defined by “Min” and “Max,” as set on the
GT-6.
When using a control pedal, foot switch, or other controller
that acts as an on/off switch, “Min” is selected with Off
(CLOSED), and “Max” is selected with On (OPEN).
that acts as an on/off switch, “Min” is selected with Off
(CLOSED), and “Max” is selected with On (OPEN).
When using an expression pedal or other controller that
generates a consecutive change in the value, the value of the
setting changes accordingly, within the range set by the
minimum and maximum values.
generates a consecutive change in the value, the value of the
setting changes accordingly, within the range set by the
minimum and maximum values.
Also, when the target is of an on/off type, the median value
of the received data is used as the dividing line in
determining whether to switch it on or off.
of the received data is used as the dividing line in
determining whether to switch it on or off.
When using the foot switch:
fig.05-12a
When using the expression pedal:
fig.05-12b
When controlling the On/Off target with the expression
pedal:
pedal:
fig.05-12c
* The range that can be selected changes according to the target
setting.
* When the “minimum” is set to a higher value than the
“maximum,” the change in the parameter is reversed.
* The values of settings can change if the target is changed after
the “minimum” and “maximum” settings have been made. If
you’ve changed the target, be sure to recheck the “minimum”
and “maximum” settings.
you’ve changed the target, be sure to recheck the “minimum”
and “maximum” settings.
Amount of Change
in parameter Value
in parameter Value
On
Foot Switch
Off
maximum value
Target Max
minimum value
Target Min
maximum value
Target Max
minimum value
Target Min
When the pedal
is fully advanced
is fully advanced
When the pedal
is fully raised
is fully raised
Expression Pedal
OFF
On
Target Max
Off
Target Min
When the pedal
is fully advanced
is fully advanced
When the pedal
is fully raised
is fully raised
When the pedal
is advanced halfway
is advanced halfway
Expression Pedal
ON