Bosch Appliances Washer/Dryer WAP24201UC Manuel D’Utilisation

21

At the factory, a temperature range, spin speed range, 

and cycle duration ("Finish at" time) are pre-set for all 

cycles.
After selection of the cycle, these values are displayed in 

the display field.
You can change the default settings as follows.

Before and during the cycle, you can change the default 

temperature range depending on the cycle progress. 
Press the appropriate button until the desired setting is 

displayed.
The maximum temperature range that can be set 

depends on the cycle selected.
~ Cycle selection table; Page 19

Before and during the cycle, you can change the spin 

speed range depending on the cycle progress. 
Press the appropriate button until the desired setting is 

displayed.
No spin setting: Rinse stop = without final spin, the 

laundry remains in the last rinse water.
The maximum speed range that can be set depends on 

the cycle selected.
~ Cycle selection table; Page 19

When you select a cycle, the duration of the cycle in 

question is displayed.
Before the cycle start, the cycle end ("Finish at" time) can 

be pre-selected in one-hour steps (h=hour) up to a 

maximum of 24h. 
Press the Delay Start button until the desired setting is 

displayed.
NOTICE:  The cycle duration is included in the set "Finish 

at" time.
After the start, the pre-selected time, e.g. 8h is displayed 

and counted down until the wash cycle begins. Then the 

cycle duration, e.g. 2:40 (hours:minutes) is displayed.

Changing the pre-selected time:
If the “Delay Start” function has been activated and 

before the wash cycle has started, you can change the 

delay time as follows:

Press Start/Pause.

Press the Delay Start button until the desired number 

of hours is displayed. 

Press the Start/Pause button

NOTICE:  The cycle duration is adjusted automatically 

when the cycle is running. Changes to the default cycle 

settings or cycle settings also cause changes in the 

cycle duration.

Auxillary rinse cycle. Longer cycle duration. For areas 

with very soft water or for further improvement of rinse 

results.

Special spin cycle with final loosening up of laundry. 

Delicate final spin - moisture remaining in the laundry is 

slightly increased.

For heavily soiled washing. Pour detergent into 

dispensers I and II.