Benq Projector MP735 Manuel D’Utilisation
Introduction
13
English
Remote control effective range
Infra-Red (IR) remote control sensor is located on the
front of the projector. The remote control must be held at
an angle within 30 degrees perpendicular to the
projector's IR remote control sensor to function correctly.
The distance between the remote control and the sensor
should not exceed
front of the projector. The remote control must be held at
an angle within 30 degrees perpendicular to the
projector's IR remote control sensor to function correctly.
The distance between the remote control and the sensor
should not exceed
7 meters (~ 23 feet).
Make sure that there are no obstacles between the remote
control and the IR sensor on the projector that might
obstruct the infra-red beam.
control and the IR sensor on the projector that might
obstruct the infra-red beam.
Replacing the remote control battery
•
Avoid excessive heat and humidity.
•
There may be battery damage if the battery is incorrectly replaced.
•
Replace only with the same or equivalent type recommended by the battery manufacturer.
•
Dispose of the used battery according to the battery manufacturer’s instructions.
•
Never throw a battery into a fire. There may be danger of an explosion.
•
If the battery is dead or if you will not be using the remote control for a long time, remove
the battery to prevent damage to the remote control from possible battery leakage.
the battery to prevent damage to the remote control from possible battery leakage.
App
rox. ±
15°
1.
Remove the battery compartment cover by
sliding the cover in the direction of the
arrow.
sliding the cover in the direction of the
arrow.
2.
Insert the supplied batteries taking note of
the polarity (+/-) as shown here.
the polarity (+/-) as shown here.
3.
Replace the cover.