Benq w6000 Manuel D’Utilisation

  25

  Using the projector

Eng
lish

Adjusting the projected image

Adjusting the projection angle 

There are four adjuster feet on the bottom of the projector. These can be 
used if necessary to change the projection angle. Screw the feet in or out as 
appropriate to aim and level the projection angle.

Correcting picture distortion

Keystoning occurs when the projector is not perpendicular to the screen and is where the projected picture 
displays visible as a trapezoid shape like either of the following:

•  Two parallel sides (left and right, or top and bottom) but is noticeably wider on either side.
• No 

parallel 

sides.

To correct the picture’s shape, you can perform the following steps.
1. Adjust the projection angle. Move the projector to be in front of the center of the screen with the center 

of the lens level with the screen.

2. If the picture is stilled distorted, or the projector is unable to be positioned as described above, you will 

need to manually correct the picture.

•  Using the remote control or projector

i. Press one of the Arrow/Keystone keys on the remote control or 

projector  (Left 

/ ,  Up 

/ ,  Right 

/ ,  Down / )  to 

display the Keystone page.

ii. See step 

 below for further operation.

•  Using the OSD menu

i. Press MENU and then press  /  until the Display menu is 

highlighted.

ii. Press   to highlight Keystone and press ENTER. The Keystone 

page displays.

iii. Highlight 2D Keystone and press ENTER. The keystone 

correction page displays.

iv. Press the key whose keystone icon is opposite to the shape of the 

projected picture. Continue pressing the same key or press the 
other keys until you are satisfied with the shape.
The values on the lower portion of the page change while 
pressing. When the values reach their maximum or minimum 
with repeated key presses, the picture’s shape will stop changing. 
You will not be able to change the picture further in that 
direction. 

/

/

 

/

.

 

/

.