Benq W5000 Manuel D’Utilisation

4 

Important safety instructions  

Eng
lish

5.

Do not block the ventilation holes while the 
projector is on (even in standby mode): 

- Do not cover the projector with any item; 
- Do not place the projector on a blanket, 

bedding or any other soft surface. 

6.

In areas where the mains power supply 
voltage may fluctuate by 

±10 volts, it is 

recommended that you connect your 
projector through a power stabilizer, surge 
protector or uninterruptible power supply 
(UPS) as appropriate to your situation.   

7.

Do not step on the projector or place any 
objects upon it.

8.

Do not place liquids near or on the projector. 
Liquids spilled into the projector will void your 
warranty. If the projector does become wet, 
disconnect it from the power point and call 
BenQ to have the projector repaired. 

9.

Do not look straight into the projector lens 
during operation. It may harm your sight. 

10. Do not operate the projector lamp beyond the 

rated lamp life. Excessive operation of lamps 
beyond the rated life could cause a lamp to 
break on rare occasions.

11. The lamp becomes extremely hot during 

operation. Allow the projector to cool for 
approximately 45 minutes prior to removing 
the lamp assembly for replacement.

12. This projector is capable of displaying 

inverted images for ceiling mount installation. 
Use only BenQ’s Ceiling Mounting Kit for 
mounting.

W20000-en.book  Page 4  Monday, October 22, 2007  3:35 PM