Benq SH960 Manuel D’Utilisation

  21

  Using the projector

Eng
lish

Selecting an input source

The projector can be connected to multiple equipment at the same 
time. When the projector is first turned on, it will attempt to reconnect 
with the input source which was in use when the projector was last 
shut down.

To select the video source:
•  Using the remote control or projector

Press one of the Source keys on the remote control, or press SOURCE 
repeatedly until your desired signal is selected.

•  Using the OSD menu

1. Press MENU/EXIT and then press  /  until the System Setup 

menu is highlighted.

2. Press  

to 

highlight 

Input Source and press ENTER. The source 

selection bar is displayed.

3. Press  /  repeatedly until your desired signal is selected and press 

ENTER.
Once detected, the selected source information will be displayed on 
the screen for seconds. If there are multiple pieces of equipment 
connected to the projector, you can go back to the source selection 
bar again to search for other signals.

•  If you want the projector to automatically search for the signals, 

select On in the System Setup > Quick Auto Search menu.

•  If you want to use the PIP function, see 

 for details.

Changing Color Space

In the unlikely event that you connect the projector to a DVD player via the projector's HDMI input and 
the projected picture displays wrong colors, please change the color space to YUV.

1. Press MENU/EXIT and then press  /  until the Display menu is highlighted.
2. Press  

to 

highlight 

Color Space Conversion and press  /  to select a suitable color space.

NOTE: When 
automatically 
searching for a valid 
input source, the 
projector cycles 
through the 
available signals 
following the 
sequence from top 
to bottom as the 
source selection bar 
shows.