Manualsbrain.com
  1. Manuels
  2. Marques
  3. Benq
  4. SH960
  5. Manuel D’Utilisation

Benq SH960 Manuel D’Utilisation

Télécharger
Page de 63
  37
  Using the projector
Eng
lish
• 
If one lamp fails, the projector enters Single-Alternative mode automatically. Dual-Brightest, Dual-
Reliable and 
Single-Eco
 settings are not available.
• 
After switching from Dual-Brightest/Dual-Reliable mode to Single-Alternative/Single-Eco mode or vice 
versa, wait for 90 seconds before you can adjust the lamp mode again.
• 
A slight variation in the picture brightness and colors may be observed during the very short time of 
switching lamp modes.
Controlling the projector through a Lan 
environment
Lan Control Settings allow you to manage the projector from a computer using a web browser when the 
computer and the projector are properly connected to the same local area network.
Configuring the Lan Control Settings
If you are in a DHCP environment:
1. Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector and the other end to 
the RJ45 port.
2. Press MENU/EXIT and then press  /  until the Advanced Setup menu is highlighted.
3. Press  
to 
highlight 
Lan Control Settings and press ENTER. The Lan Control Settings page is 
displayed.
4. Press  
to 
highlight 
Control By and press  /  to select 
RJ45
.
5. Press  
to 
highlight 
DHCP and press  /  to select On.
6. Press  
to 
highlight 
AMX Device Discovery and press  /  to select On or Off. When AMX Device 
Discovery is On, the projector can be detected by AMX controller.
7. Press  
to 
highlight 
Apply and press ENTER.
8. Please wait for around 15 - 20 seconds, and then re-enter the Lan Control Settings page.
9. The Projector IP Address, Subnet Mask, Default Gateway, and DNS Server settings will be displayed. 
Note down the IP address displayed in the Projector IP Address row.
If the Projector IP Address still does not display, contact your ITS administrator.
If you are in a non-DHCP environment:
1. Repeat steps 1-4 above.
2. Press  
to 
highlight 
DHCP and press  /  to select Off.
3. Contact your ITS administrator for information on the Projector IP Address, 
Subnet Mask
, Default 
Gateway, and DNS Server settings.
4. Press   to select the item you want to modify and press ENTER.
5. Press  /  to move the cursor and then press  /  to enter the value.
6. To save the setting, press ENTER. If you do not want to save the setting, press MENU/EXIT.
7. Press  
to 
highlight 
AMX Device Discovery and press  /  to select On or Off.
8. Press  
to 
highlight 
Apply and press ENTER.