Benq W10000 Manuel D’Utilisation

32 

Additional information  

English

To clean the filter:

1.

Shut down the projector if turned on and wait 
until the fans stop running. 

2.

Release the bottom edge of the filter cover (right 
side of projector) by gently pulling the tabs on the 
lower ends of the panel (as illustrated). 

3.

Remove the filter cover by gently lifting the 
loosened cover vertically upwards and then away 
from the projector body. 

4.

Remove the dust filter grill by pulling the tab 
outwards and away from the projector. 

5.

Use a small vacuum cleaner (designed for 
computers and other office equipment) or use a 
soft brush (such as a clean artist’s paintbrush) to 
vacuum or sweep the dust away. 

•

If the dirt is difficult to remove or the filter is 
broken, you should replace it.

6.

Re-install the filter grill and cover securely. 

7.

Reapply power and turn the projector on.

•

If the filter grill is not correctly seated in place, 
you will be reminded by a message displayed 
on the screen every three minutes until 
MENU/EXIT on the projector or EXIT on the 
remote control is pressed. 

•

The projector will automatically shut down 
within minutes if there has been no further 
action taken. Re-install the filter and cover 
securely, then turn on the power again.

8.

Go to Setup > Reset Dust Filter Timer to reset the 
filter timer. 

 for details.