Benq SH960 Manuel D’Utilisation

20 

Using the projector  

Eng
lish

Using the projector

Preparations
1. Plug in and turn all of the connected equipment on.
2. If not already in, plug the supplied power cable into the AC inlet 

on the rear of the projector.

3. Plug the power cable into a wall power outlet and turn the wall 

switch on.

Turning the projector on

Follow the steps below.

1. Make sure the Power light is orange after power has been applied.
2. Press POWER ( ) on the projector or ON   on the remote control 

to start the projector. As soon as the lamp lights up, a "Power On 
Tone" will be heard.
To turn of the ring tone, see 

 for details.

3. The fans will start operating, and a start-up image will be displayed 

on the screen for a few seconds while it warms up.

4. If the projector is activated for the first time, select your OSD language following the on-screen 

instructions.

5. If you are prompted for a password, press the arrow keys to enter a six-digit password. See 

 for details.

6. Press one of the Source keys on the remote control, or press SOURCE on the projector repeatedly until 

your desired signal is selected. See 

 for details.

7. If the horizontal frequency of the input source exceeds the range of the projector, the message "No 

Signal" will be displayed on the screen. This message will remain on-screen until you change the input 
source to an appropriate one.