Benq Projector SH940 Manuel Du Propriétaire

  21

  Using the projector

En

glish

The projector can be connected to multiple equipment at the same 
time. When the projector is first turned on, it will attempt to 
reconnect with the input source which was in use when the 
projector was last shut down.

Press one of the Source keys on the remote control, or press 
SOURCE on the projector repeatedly until your desired signal is 
selected.

1. Press MENU on the projector or MENU/EXIT on the remote 

control, and then press  /  until the System Setup menu is 
highlighted.

2. Press  

to 

highlight 

Input Source and press ENTER. The 

source selection bar is displayed.

3. Press  /  repeatedly until your desired signal is selected and 

press ENTER.
Once detected, the selected source information will be displayed 
on the screen for seconds. If there are multiple pieces of 
equipment connected to the projector, you can go back to the 
source selection bar again to search for other signals.

•  If you want the projector to automatically search for the signals, 

select On in the System Setup > Auto Source Search menu.

•  If you want to use the PIP function, see 

 for details.

In the unlikely event that you connect the projector to a DVD player via the projector's HDMI input and 
the projected picture displays wrong colors, please change the color space to YUV.

1. Press MENU/EXIT and then press  /  until the Display menu is highlighted.
2. Press  

to 

highlight 

Color Space Conversion and press  /  to select a suitable color space.

NOTE: When 

automatically 

searching for a valid 

input source, the 

projector cycles 

through the available 

signals following the 

sequence from top to 

bottom as the source 

selection bar shows.

SH940_EN.book  Page 21  Wednesday, October 3, 2012  2:36 PM