Benq MS524/MS514H/MX525/MW526/TW526 Manuel D’Utilisation

Operation

Adjusting the projected image

Adjusting the projection angle

The projector is equipped with 1 adjuster foot. It

changes the image height and projection angle. To

adjust the projector, screw the adjuster foot to fine-

tune the horizontal angle.

To retract the foot, screw the rear adjuster foot in a

reverse direction.

If the projector is not placed on a flat surface or the

screen and the projector are not perpendicular to

each other, the projected image becomes

trapezoidal. To correct this situation, see

for details.

Auto-adjusting the image

In some cases, you may need to optimize the picture quality. To do this, press AUTO on

the projector or remote control. Within 3 seconds, the built-in Intelligent Auto

Adjustment function will re-adjust the values of Frequency and Clock to provide the best

picture quality.

The current source information will be displayed in the corner of the screen for 3 seconds.

This function is only available when PC signal (analog RGB) is selected.

Fine-tuning the image size and clarity

Do not look into the lens while the

lamp is on. The strong light from the

lamp may cause damage to your eyes.
Be careful when you press the quick-

release button as it is close to the

exhaust vent where hot air comes

from.

Adjust the projected image to the
size that you need using the zoom
ring.

Sharpen the image by rotating the
focus ring.