Benq MP510 Manuel D’Utilisation
Maintenance
42
Replacing the lamp
•
To reduce the risk of electrical shock, always turn the projector off and disconnect the
power cord before changing the lamp.
power cord before changing the lamp.
•
To reduce the risk of severe burns, allow the projector to cool for at least 45 minutes
before replacing the lamp.
before replacing the lamp.
•
To reduce the risk of injuries to fingers and damage to internal components, use caution
when removing lamp glass that has shattered into sharp pieces.
when removing lamp glass that has shattered into sharp pieces.
•
To reduce the risk of injuries to fingers and/or compromising picture quality by touching
the lens, do not touch the empty lamp compartment when the lamp is removed.
the lens, do not touch the empty lamp compartment when the lamp is removed.
•
This lamp contains mercury. Consult your local hazardous waste regulations to dispose of
this lamp in a proper manner.
this lamp in a proper manner.
If this warning message displays, the projector will
shut down in 40 seconds. The lamp MUST be
replaced before the projector will operate normally.
shut down in 40 seconds. The lamp MUST be
replaced before the projector will operate normally.
Then reset lamp timer
Replace lamp (refer to User Manual)
Lamp-usage time exceeded
1.
Turn the power off and disconnect the
projector from the wall socket. If the lamp is
hot, avoid burns by waiting for approximately
45 minutes until the lamp has cooled.
projector from the wall socket. If the lamp is
hot, avoid burns by waiting for approximately
45 minutes until the lamp has cooled.
2.
Turn the projector over. Then loosen the
screws on the lamp cover.
screws on the lamp cover.
3.
Remove the lamp cover from the projector.
Do not turn the power on with the lamp cover
removed.
4.
Remove the lamp cords from the slots.