Benq Dlp Projector MX662 Manuel Du Propriétaire

Operation

24

Press   to highlight Power On Lock and press  /  to select Off. You will 
not have to enter the password next time when turning on the projector.

ii. If the password is incorrect, the password error message appears lasting for 

three seconds, and the message “INPUT PASSWORD” appears for your 
retry. You can press MENU/EXIT to cancel the change or try another 
password.

Though the password function is disabled, you need to keep the old password in hand should you ever need to 

re-activate the password function by entering the old password.

Switching input signal

The projector can be connected to multiple devices at the same time. However, it can only 

display one full screen at a time. When starting up, the projector automatically searches for 

the available signals.

Be sure the Quick Auto Search function in the SOURCE menu is On if you want the 

projector to automatically search for the signals.

To select the source:

1.

Press SOURCE on the projector or remote 
control. A source selection bar appears. 

2.

Press  /  until your desired signal is selected 
and press MODE/ENTER.
Once detected, the selected source information 
will display at the corner of the screen for 
seconds. If there is multiple equipment connected 
to the projector, repeat steps 1-2 to search for 
another signal.

• 

The brightness level of the projected image will change 

accordingly when you switch between different input signals. 

Data (graphic) "PC" presentations using mostly static images 

are generally brighter than "Video" using mostly moving images 

(movies).

• 

The native display resolution of this projector is in a 4:3 

(MX662)/16:10 (MW663) aspect ratio. For best display picture 

results, you should select and use an input signal which outputs 

at this resolution. Any other resolutions will be scaled by the 

projector depending upon the “aspect ratio” setting, which may 

cause some image distortion or loss of picture clarity. See 

 for 

details.

• 

Firewall in the PC must be switched off to allow USB Display to work.

Changing Color Space

In the unlikely event that you connect the projector to a DVD player via the projector’s 

HDMI input and the projected picture displays wrong colors, please change the color 

space to YUV.

To do this:
1.

Press MENU/EXIT and then press  /  until the SOURCE menu is highlighted.

2.

Press   to highlight Color Space Conversion and press  /  to select a suitable 
color space.

This function is only available when the HDMI-input port is in use.