Benq SP831 Manuel D’Utilisation
32
Operation
Securing the projector
Using a security cable lock
The projector has to be installed in a safe place to prevent stealing. If not, purchase a lock,
like Kensington lock, to secure the projector. You can locate a Kensington lock slot on the
rear side of the projector. See item 26 on page
like Kensington lock, to secure the projector. You can locate a Kensington lock slot on the
rear side of the projector. See item 26 on page
for details.
A Kensington security cable lock is usually the combination of key(s) and lock. Refer to the
lock’s documentation about how to use it.
lock’s documentation about how to use it.
Utilizing the password function
For security purposes and to help prevent unauthorized use, the projector includes an
option for setting up password security. The password can be set through the On-Screen
Display (OSD) menu. Once the password is set and this function is selected, the projector is
password-protected. Users who do not know the correct password can not use the projector.
option for setting up password security. The password can be set through the On-Screen
Display (OSD) menu. Once the password is set and this function is selected, the projector is
password-protected. Users who do not know the correct password can not use the projector.
You will be inconvenienced if you activate the password functionality and subsequently forget
the password. Print out this manual (if necessary) and write the password you used in this
manual, and keep the manual in a safe place for later recall.
the password. Print out this manual (if necessary) and write the password you used in this
manual, and keep the manual in a safe place for later recall.
Setting a password
Once a password has been set and activated, the projector cannot be used unless the correct
password is entered every time the projector is started.
password is entered every time the projector is started.
1.
Press MENU on the projector or remote control
and then press /
and then press /
until the Advanced Setup
menu is highlighted.
2.
Press to highlight Password and press ENTER.
The Password page displays.
The Password page displays.
3.
Highlight Password and press /
to select On.
The Input Password page displays.
4.
As the picture indicates, the four arrow keys (
,
,
,
) respectively represent 4 digits (1, 2,
3, 4). According to the password you desire to set,
press the arrow keys on the remote control or
projector to enter six digits for the password.
Once the password is set, the OSD menu returns
to the Password page.
press the arrow keys on the remote control or
projector to enter six digits for the password.
Once the password is set, the OSD menu returns
to the Password page.
IMPORTANT: The digits being input will display as
asterisks on-screen. Write your selected password
down here in this manual in advance or right after
the password is entered so that it is available to
you should you ever forget it.
asterisks on-screen. Write your selected password
down here in this manual in advance or right after
the password is entered so that it is available to
you should you ever forget it.
Password: __ __ __ __ __ __
Keep this manual in a safe place.
Keep this manual in a safe place.
5.
To leave the OSD menu, press MENU.
Lamp
Audio
Pattern
High Altitude Mode
Audio
Pattern
High Altitude Mode
Password
Key Lock
Reset All Settings
Reset All Settings
Advanced Setup
EXIT Back
Analog RGB
ENTER
Off
Input Password
Password
Password
Change Password
Off
EXIT Clear
EXIT Back