Benq Digital Projector MP782 ST Manuel D’Utilisation

Operation

24

Operation

Starting up the projector

1.

Plug the power cord into the projector and into a 
power outlet. Turn on the power outlet switch 
(where fitted). Check that the POWER indicator 
light on the projector lights orange after power has 
been applied.

2.

Open the lens cover. If it is closed, it could become 
deformed due to the heat produced by the 
projection lamp.

3.

Press  

Power on the projector or remote 

control to start the projector. The POWER 
indicator light flashes green and stays green 
when the projector is on.

The start up procedure takes about 30 seconds. 
In the later stage of start up, a startup logo is 
projected.

(If necessary) Rotate the focus ring to adjust the 
image clearness.

4.

If the projector is activated for the first time, 
select your OSD language following the on-
screen instructions.

5.

If you are prompted for a password, press the 
arrow keys to enter a six-digit password. See 

 

for details.

6.

Switch all of the connected equipment on.

7.

The projector will start to search for input 
signals. The current input signal being scanned 
displays in the upper left corner of the screen. 
If the projector doesn't detect a valid signal, the message “No Signal” will continue 
displaying until an input signal is found.

You can also press SOURCE on the projector or remote control to select your desired 
input signal. See 

 for details.