BENDIX BW2867 Manuel D’Utilisation

ODO:

127mi

Load Rear: 58420lb

Inst. Test Missing

DISCLAIMER

For information

only! Press any key

to continue.

SUPPLY: 11.9V 58368LB

ODO: 127MI

Bendix TIM

™

TABS-6

™

Advanced ABS

Inst. Test Missing

TPMS Info

Main Menu

Exit

DISCLAIMER

For information

only! Press any key

to continue

<Active

DTCs >

ODO:

127mi

Main Menu

Exit

BATTERY MODE

For information

only! Values are

read from memory!

Initial Menu

Main Menu

Stored

DTCs

Distance & Serv.

Operating Info

ECU Info

Main Menu

Stored

DTCs

Distance & Serv.

Operating Info

System Info

Scroll until

“Main Menu”

Scroll until “Main Menu”

TPMS symbol

(where used)

Bendix TIM

™

TABS-6

™

Advanced ABS

DISPLAYS

With the ignition “ON”

The display is automatically activated. All menus are

available.

With the ignition “OFF”

The display is off, push any navigation button for one second to

activate the display. Only limited menus are available.

SAFE MAINTENANCE PRACTICES

WARNING! PLEASE READ AND FOLLOW

THESE INSTRUCTIONS TO AVOID PERSONAL

INJURY OR DEATH:

When working on or around a vehicle, the following general precautions

should be observed at all times:
1. Park the vehicle on a level surface, apply the parking brakes, and

always block the wheels. Always wear safety glasses. Where

specifically directed, the parking brakes may have to be released,

and/or spring brakes caged, and this will require that the vehicle be

prevented from moving by other means for the duration of these tests/

procedures.

2. Stop the engine and remove ignition key when working under or

around the vehicle. When working in the engine compartment, the

engine should be shut off and the ignition key should be removed.

Where circumstances require that the engine be in operation,

EXTREME CAUTION should be used to prevent personal injury

resulting from contact with moving, rotating, leaking, heated or

electrically charged components.

3. Do not attempt to install, remove, disassemble or assemble a

component until you have read and thoroughly understand the

recommended procedures. Use only the proper tools and observe

all precautions pertaining to use of those tools.

4. If the work is being performed on the vehicle’s air brake system,

or any auxiliary pressurized air systems, make certain to drain the

air pressure from all reservoirs before beginning ANY work on the

vehicle. If the vehicle is equipped with a Bendix

AD‑IS

air dryer

system or a dryer reservoir module, be sure to drain the purge

reservoir.

5. Following the vehicle manufacturer’s recommended procedures,

deactivate the electrical system in a manner that safely removes all

electrical power from the vehicle.

6. Never exceed manufacturer’s recommended pressures.
7. Never connect or disconnect a hose or line containing pressure; it

may whip. Never remove a component or plug unless you are certain

all system pressure has been depleted.

8. Use only genuine Bendix

brand replacement parts, components

and kits. Replacement hardware, tubing, hose, fittings, etc. must

be of equivalent size, type and strength as original equipment and

be designed specifically for such applications and systems.

9. Components with stripped threads or damaged parts should be

replaced rather than repaired. Do not attempt repairs requiring

machining or welding unless specifically stated and approved by the

vehicle and component manufacturer.

10. Prior to returning the vehicle to service, make certain all components

and systems are restored to their proper operating condition.

11. For vehicles with Automatic Traction Control (ATC), the ATC function

must be disabled (ATC indicator lamp should be ON) prior to

performing any vehicle maintenance where one or more wheels on

a drive axle are lifted off the ground and moving.