Beckett CG10 Manuel D’Utilisation
27
CG10 Burner Manual
Test/Inspection
Frequency
Comments
Inspect area surrounding heating plant
Daily
Keep area clean and free of clutter
Inspect gas supply system for leaks
Daily
Use visual and electronic leak detection
Inspect appliance & piping for water leaks
Daily
Keep burner and controls dry at all times
Inspect gauges, indicators, monitors
Daily
Note condition. Replace defective parts
Check temperature and pressure levels
Daily
Compare to manufacturer’s specifi cations
Make visual inspection of fl ame
Daily
Look for changes in shape, size, and color.
Monitor burner start-up
Daily
Verify prompt ignition and fl ame stability.
Monitor stack temperature
Daily
Compare to start-up and trend level.
Test low water cutoff and alarm
Daily
Follow control manufacturer’s instructions & procedures
in ASME Boiler & Pressure Vessel Code, Section VI
- Recommended Rules for Care and Operation of
Heating Boilers.
in ASME Boiler & Pressure Vessel Code, Section VI
- Recommended Rules for Care and Operation of
Heating Boilers.
Calculate fuel gas input fi ring rate
Weekly
Compare to appliance manufacturer’s Specifi cations
Check fl ame safeguard sequence of
operation.
operation.
Weekly
Follow control manufacturer’s instructions
Flame failure response & lockout timing.
Weekly
Follow control manufacturer’s instructions
Flame sensor signal level (if meter is hard-
wired)
wired)
Weekly
Compare to control manufacturer’s specifi cations
Main fuel gas valves
Weekly
Open high limit and verify cutoff operation
Inspect exhaust vent system for blockage
Weekly
Remove any restrictions
Inpect compbustion air supply
Monthly
Remove any restrictions
Check high and low gas pressure interlocks Monthly
Follow control manufacturer’s instructions
Check safety valves
As needed
Follow control manufacturer’s instructions & procedures
in ASME Boiler & Pressure Vessel Code, Section VI
- Recommended Rules for Care and Operation of
Heating Boilers.
in ASME Boiler & Pressure Vessel Code, Section VI
- Recommended Rules for Care and Operation of
Heating Boilers.
Table 4 - Periodic Inspection Sheet
For the OPERATOR
Inspect Heating System Regularly
Lack of regular inspections and inadequate maintenance could lead to equipment malfunction and
result in asphyxiation, explosion or fi re.
(Always follow the appliance manufacturer’s recommended service instructions, when available.)
The following checklist is intended to be used as a minimum reference guide only and does not supersede
or replace the heating appliance manufacturer’s recommended service and maintenance instructions or
any code requirements.
Consult the installation and service instructions provided by the individual control or component
manufacturer and carefully follow their directions.
Maintenance and testing may be required more frequently due to dusty or severe operating conditions.
If unusual or questionable performance is observed, shut the system down and contact your qualifi ed
service agency immediately.
or replace the heating appliance manufacturer’s recommended service and maintenance instructions or
any code requirements.
Consult the installation and service instructions provided by the individual control or component
manufacturer and carefully follow their directions.
Maintenance and testing may be required more frequently due to dusty or severe operating conditions.
If unusual or questionable performance is observed, shut the system down and contact your qualifi ed
service agency immediately.
y
y
y
y
y
Section: Maintenance and Service