Beckett AFII Manuel D’Utilisation

AFII Burner Manual

Thank you for purchasing a Beckett 
burner for use with your heating appliance.  
Please pay attention to the Safety Warnings 
contained within this instruction manual. 
Keep this manual for your records and 
provide it to your qualifi ed service agency 
for use in professionally setting up and 
maintaining your oil  burner.

Your Beckett burner will provide years of 
effi cient operation if it is professionally 
installed and maintained by a qualifi ed 
service technician. If at any time the burner 
does not appear to be operating properly, 
immediately contact your qualifi ed 
service agency for consultation.

Daily – Check the room in which your 

burner/appliance is installed.  Make sure:

Air ventilation openings are clean and 
unobstructed
Nothing is blocking burner inlet air 
openings
No combustible materials are stored 
near the heating appliance
There are no signs of oil or water 
leaking around the burner or appliance

Weekly  

Check your oil tank level.  Always 
keep your oil tank full, especially 
during the summer, in order to prevent 
condensation of moisture on the inside 
surface of the tank.

y

y

y

y

y

▼

▼

Hazard Defi nitions  ........................................................................ 4

Clearances to Burner and Appliance ............................................. 5
Combustion Chamber and Burner Retrofi tting .............................. 5
Inspect Chimney or Direct Vent System ........................................ 5
Combustion Air Supply Information ............................................... 7
Direct/Sidewall Venting Application  .............................................. 7

General ......................................................................................... 8
Installing the Oil Tank and Supply System .................................... 8
Fuel Line Valves and Filter  ........................................................... 8
Mount Burner on Appliance ........................................................... 9
Connect Fuel Lines ....................................................................... 9

Burner packaged with appliance ................................................... 9
Burner installed at jobsite .............................................................. 9
Special wiring required with covered burners ............................... 9

GeniSys Model 7505 Control ...................................................... 10
Features ...................................................................................... 10
Wiring .......................................................................................... 10
Reset Button Operation ............................................................... 12
Wire Burner ................................................................................. 14

Set combustion with instruments            ..................................... 14

Shutting the Burner Off ............................................................... 16
Removing Nozzle Line for Service .............................................. 16
Nozzle Installation  ...................................................................... 16
Check/Adjust Electrodes ............................................................. 17
Blower Wheel Replacement ........................................................ 17