Bühler 2895E Manuel D’Utilisation

Page de 46
bühler
Allied Front-End Loader 
- 16 - 
P4493 
When loading bales onto a trailer, park trailer 
in close proximity to minimize turning angle 
and length of travel to increase loading 
efficiency.
As you lift the bale using the regular loader, it 
is recommended to feather the valve to allow 
bucket cylinders to extend to keep bale at 
about a 20
q angle.  (On TSL loaders this is 
not necessary)  Lift the bale only enough to 
clear the area that the bale will be placed on.  
Always approach the trailer square to the 
tractor as shown. 
CAUTION
Avoid sudden stops and sharp turns.  Avoid uneven terrain areas for loading and 
unloading. 
After setting the bale down position the A – 
frame with spear(s) horizontal to the ground 
and slowly back the tractor straight out. 
With pallet forks level and just above the 
ground, drive the forks into the pallet 
completely.  Raise loader to lift pallet and 
carry level 6 to 12 inches off the ground. 
Note:
The TSL loader is highly 
recommended when operating with pallet 
forks for maintaining a constant level load. 
Use the level indicator as a guide to ensure 
forks are level at ground.
CAUTION
Avoid sudden stops and sharp turns.  Operate at low ground speeds.  Never 
attempt to lift loads heavier than the rated fork specs (42”– 2200 lbs.) (48”– 4400 
lbs.).  Always lift or carry pallets using both forks and utilizing the full length of the 
forks.
WARNING 
When driving amongst livestock keep bucket cylinders retracted, and loader 
boom at least 6 to 7’ off the ground.  Store A – frame away from both play and 
heavy traffic areas. 
Level indicator