Bühler 2895E Manuel D’Utilisation

bühler

Allied Front-End 

Loader

  

                                                                             P4493 

- 40 -

Regular loader linkage setup allows for 
maximum rollback. 

TSL loader linkage setup provides reduced 
rollback.

When fully rolled back, large attachments 
(such as the C2000 Grapple) may contact 
the 2895E TSL or the 2895E S TSL pivot 
plate.  This interference is avoided in 
factory assembly by installing the linkages 
(item 12) in the limited rollback position. 
These linkages can be reversed to 
increase attachment rollback if large 
attachments are not used.  See following 
description below to reverse links. 

Before reversing the linkages, remove 
attachments and engage the hydraulic 
loader lock (refer to page 23 for hydraulic 
loader lock instructions). 

Refer to pages 36 and 37 for 
corresponding item and part numbers. 

Remove the 1.25 x 7.25 pin (item 40) 
connecting the linkages (items 11 & 12). 

Remove the 1.25 x 6.25 pin (item 17) 
connecting the linkages (item 12) to the 
quick attach (item 2). 

Reverse the all four linkages (item 12), and 
reinstall pins and quick attach. 

Note: For maximum rollback, the flat side of 
the linkages (item 12) with one notch should be 
facing forward.  For limited rollback, the arced 
side of the linkages with two notches should be 
facing forward.