Bosch Appliances Satellite Radio MIYN46 Manuel D’Utilisation

en | Installation

MIYN46 Wall Transmitter

970.035b | F.01U.278.521 | v2.0 | 2012.12

User Manual US

Bosch Security Systems

The MIYN46 Wall Transmitter can be powered by a lithium battery or/and an external 12-24 

VDC power supply. If the device is powered with an external power supply, the battery is not 

necessary, but it can be used as a backup power supply in case of power loss. 

If the device is powered by the battery only, the battery life is about 2 years. However, it is 

recommended to change the battery once a year.

If the device is powered by an external power supply and the battery is used as backup power 

supply, it is recommended to check it at regular intervals (for instance once a year) and to 

change it if necessary.

All parameters are reset when powering up the device (battery or external power supply). This 

operation causes the synchronization of the daily message.

In order to perform a reset, make sure to remove both the battery and the external power sup-

ply, make a short-circuit on the two pins marked Reset before powering the device up again. 

See Section Fig. 4.2

Configuration and Wiring, page 14.

All MIYN46 Wall Transmitters are provided with their own radio identification code that is 

assigned in the factory. During the installation, it is necessary to set the relationship between 

the identification code of the Transmitter and the place where it is installed (floor/room/bed 

or single number). This identification is programmed on the Main Unit (refer to the Main Unit 

User Manual).

Once the transmitter has been installed and setup properly, it is recommended to check all 

functionalities of the device. The radio transmission can be checked by sending an acknowl-

edgement call by pressing the green button.

When powering the device, the external 12-24 VDC power supply must be equipped with a 

setting off safety device, that is easy to access. The power supply must also be equipped with 

a safety fuse of lower value, e.g. 100 or 125 mA.

All connections as well as the configuration need to be carried out before powering the device 

(insertion of the battery and/or application of the external power supply).