Wolf WEG24R Manuel D’Utilisation
-
3
-
LEG ASSEMBLY
Attach the legs to the body by threading the exposed leg stud into the threaded holes
located on the underside of the unit.
Tighten each leg so that the top face of the leg is pressed firmly against the body bottom.
Do not operate griddle without legs or integrated stand as damage will occur.
LEVELING
Position the griddle in the desired location. Level the griddle by using a wrench to turn
the adjustable feet. You must hold the leg while turning the foot so that it’s attachment to
the griddle is not loosened.
LOCATION
Attach the legs to the body by threading the exposed leg stud into the threaded holes
located on the underside of the unit.
Tighten each leg so that the top face of the leg is pressed firmly against the body bottom.
Do not operate griddle without legs or integrated stand as damage will occur.
LEVELING
Position the griddle in the desired location. Level the griddle by using a wrench to turn
the adjustable feet. You must hold the leg while turning the foot so that it’s attachment to
the griddle is not loosened.
LOCATION
The installation location must be kept free and clear of combustibles. Do not permit air to
blow directly at the griddle. Avoid open windows next to the griddle wherever possible.
Avoid wall-type fans which create air cross-currents within the room.
blow directly at the griddle. Avoid open windows next to the griddle wherever possible.
Avoid wall-type fans which create air cross-currents within the room.
This griddle is Design Certified for installation on a non-combustible counter with 4” legs,
or combustible floor with 25” high stand.
or combustible floor with 25” high stand.
INSTALLATION CLEARANCES
COMBUSTIBLE CONSTRUCTION NON-COMBUSTIBLE CONSTRUCTION
Back: 1”
0”
Right 1”
0”
Left Side
1”
0”
ELECTRICAL CONNECTIONS
Electrical and grounding connections must comply with the
applicable portions of the National Electrical Code and/or other local electrical
codes.
codes.
Disconnect the electrical power to the griddle and follow lockout /
tagout procedures.
Standard Electrical Connections
1. Remove the small cover plate on the back of the unit. This exposes the built-in junction box and
griddle line leads.
2. Select a suitable knockout on the rear or bottom of the junction box.
3. Connect the griddle’s line leads to the supply wires with the factory supplied connectors as shown in
the applicable wiring diagrams.
4. Push the excess wire into the junction box and replace the cover plate. Never operate griddle
without cover in place.
griddle line leads.
2. Select a suitable knockout on the rear or bottom of the junction box.
3. Connect the griddle’s line leads to the supply wires with the factory supplied connectors as shown in
the applicable wiring diagrams.
4. Push the excess wire into the junction box and replace the cover plate. Never operate griddle
without cover in place.