Wright Manufacturing 3234-33 Manuel D’Utilisation
21
5.3 Belt Tension Adjustment
The pump drive belt is self-adjusting, and requires no adjustment, just replacement. The blade drive belt is
self-adjusting also and requires no adjustment, just replacement.
self-adjusting also and requires no adjustment, just replacement.
5.3.1Replacing the Cutter Deck Belt
•
Stop engine and remove the key and wait for all moving parts to stop.
•
Remove deck covers
•
Remove belt by using a ½” ratchet and extension to relieve belt tension. (See figure)
.
5.3.2 Replacing the Drive Belt
•
Stop engine and remove the key and wait for all moving parts to stop.
•
Remove the deck covers and remove the engine to blade belt. (Refer to replacing the cutter deck
belt section)
•
Raise front of unit and secure
•
Remove the clutch stop
•
Remove belt
•
Reinstall in reverse order. Figure below shows belt configuration.
•
NOTE: Ensure clutch stop is reinstalled