West Elm Tiled Capiz Mirror Instructions De Montage
page 1 of 1
mounting instructions
NOTE:
• Stud mounting is recommended. Use proper hardware
for your wall type (such as anchors for drywall). When
in doubt, consult your local hardware store. For your
safety, installation by two people is recommended.
for your wall type (such as anchors for drywall). When
in doubt, consult your local hardware store. For your
safety, installation by two people is recommended.
• This mirror can be mounted either way horizontally.
• Wipe with a soft, dry cloth. To protect the finish, avoid
the use of all chemicals and household cleaners.
the use of all chemicals and household cleaners.
drywall anchor 2x
screw 2x
A
B
1. Hold mirror at desired location. With a pencil, mark on wall the top
center edge of the mirror. This will be point “C” on the template.
center edge of the mirror. This will be point “C” on the template.
2. Tape the template to the wall, with the point “C” at the pencil mark
on the wall. Use a carpenter's level to ensure that points X1 and X2
are level. With a tack or nail, mark through the template at points X1
and X2. These will be the insertion points for the hardware. Remove
the template.
on the wall. Use a carpenter's level to ensure that points X1 and X2
are level. With a tack or nail, mark through the template at points X1
and X2. These will be the insertion points for the hardware. Remove
the template.
3. For stud mounting: skip to step 4. For drywall mounting: using a
Philip's head screwdriver, insert the drywall anchors (A) into the
wall at the insertion points. Press and turn clockwise until anchors
are flush with the wall.
Philip's head screwdriver, insert the drywall anchors (A) into the
wall at the insertion points. Press and turn clockwise until anchors
are flush with the wall.
4. Insert screws (B) into the anchors or at the insertion points, leaving
approximately 1/2" between the back of the screw head and the wall.
approximately 1/2" between the back of the screw head and the wall.
5. Align keyhole notches over the screw heads.
6. Slide the mirror down until it rests on the screws. Tighten or loosen
screws as needed to fit the mirror snugly against the wall.
screws as needed to fit the mirror snugly against the wall.
!
For drywall mounting, use anchors with screws.
For stud mounting, use screws only.
6
3-5
A
B
: tiled capiz mirror
paper template 1x
5648910 - 2/26