West Elm Teak Bath Sconce Single Instructions De Montage

Important Safety Instructions:

·Stud mounting is recommended. Use proper hardware for your wall type. When in doubt consult your local hardware

store. For your safety, it is strongly recommended that two people hang the lamp.

·Electric bulb should be centered inside the pendant shade, making sure it does not touch the outer sides.

·These instructions are provided for your safety. It is important that they are read carefully and completely before

assembling fixture.

·This fixture has been rated for up to (1) 60-watt TYPE B bulb (not included). To avoid the risk of fire, do not exceed the

recommended wattage.

assembly instructions

page 1 of 2

Warning:

·To reduce the risk of fire, electrical shock or personal injury, always turn off

and unplug lamp and allow it to cool prior to replacing light bulb.

·Do not touch bulb when fixture is turned on. Do not look directly at lit bulb.

·Keep flammable materials away from lit bulb.

Pre-assembly:

·Remove all parts and hardware from box along with any plastic protective packaging.

·Do not discard any contents until after assembly is complete to avoid accidentally discarding small parts or hardware.

·For your safety and convenience, assembly by two people is recommended

Parts Enclosed:

• (1) Mounting plate (J)

• (1) Canopy (L)

• (1) Lamp Socket (I)

• (1) Socket Ring (F)

• (1) Screw Cap (K)

• (1) Glass Shade (H)

Hardware Included:

• (1) Mounting screws (C)

• (2) Green ground screws (B)

• (3) Plastic wire caps (A)

• (4) Canopy screws ( D )

To install you will need:

• Electrical tape

• Screwdriver

teak bath sconce single

5626221 - 03/08

grounding screw 2x

mounting screws

wire caps

canopy screws 4x

To Assemble:

1. SHUT OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN

FUSE BOX/CIRCUIT BREAKER.

2. Carefully unpack all fixture parts and hardware and lay out

on a clear workspace.

3. Carefully inspect the chandelier's fixture wires. The

NEUTRAL FIXTURE WIRE is white or marked “N”. The HOT

FIXTURE WIRE is black or marked “L”. The yellow-green or bare

wire is the GROUND WIRE.