Whirlpool SF216LXSQ Guide D’Installation Rapide

1. Refer to the “Make Gas Connection” section for properly 

connecting the range to the gas supply.

2. Turn the manual shutoff valve in the gas supply line to the 

open position.

3. Refer to the “Electronic Ignition System” section for proper 

burner ingestion, operation and burner flame adjustments.

IMPORTANT: You may have to adjust the “LO” setting for 
each cooktop burner.

Checking for proper cooktop and oven burner flames is very 
important. The small inner cone should have a very distinct 
blue flame ¼" to ½" (0.64 cm to 0.13 cm) long. The outer 
cone is not as distinct as the inner cone. LP gas flames have 
a slightly yellow tip.

4. Close the broiler door and press the CANCEL/OFF pad.

5. Refer to the “Complete Installation” section to complete this 

procedure.

1. Turn manual shutoff valve to the “closed” position.

2. Unplug range or disconnect power.

1. Open broiler door and remove broiler pan. The gas pressure 

regulator is located in the back right hand corner of the broiler 
compartment.

IMPORTANT: Do not remove the gas pressure regulator.

NOTE: Do not remove the spring beneath the cap.

2. Remove the cap from the gas pressure regulator using a flat-

blade screwdriver.

NOTE: Make sure sealing washer remains in the same 
position.

3. To convert to Natural gas, unscrew the plastic adjustment 

screw by hand, turn it over, and screw it in again.

4. Reinstall the cap.

A

B

C

A

A

C

A

B