VTech IP Phone DS6472-6 Manuel D’Utilisation

13

Your telephone base is ready for tabletop use. If you want to mount your

If you want to mount your 

telephone on a wall, use the provided wall mount bracket to connect with 

a standard dual-stud telephone wall mounting plate. If you do not have this 

mounting plate, you can purchase one from many hardware or consumer 

electronics retailers. You may need a professional to install the mounting plate.

Plug one end of the telephone line cord into the 

TEL LINE jack on the 

bottom of the telephone base. Plug the small end of the telephone base 

power adapter into the 

POWER jack on the bottom of the telephone base. 

Position the lower portion grooves on the telephone base to the lower 

portion tabs (marked 

B) on the wall mount bracket. Make sure the upper 

portion grooves of the telephone base are above the upper portion tabs 

(marked 

A) on the wall mount bracket. Push the telephone base down 

until it clicks securely in place.
Route the telephone line cord (or DSL filter) through the wall mount 

bracket hole and plug it into the telephone wall jack. Route the power cord 

out of the bottom of the telephone and plug it into an electrical outlet not 

controlled by a wall switch.
Align the holes on the bracket with the standard wall plate and slide the 

bracket down until it locks securely. Bundle the telephone line cord and 

power adapter cord neatly with twist ties.

1.

2.

3.

4.

1

3

2

4