Swisher 11730 Manuel D’Utilisation
Item #
Part #
Description
9
10111TK
Bracket - Motor Support, Upper
11
10114TK
Bracket - Motor Support, Lower
12
10197
Bolt - Carriage 5/16-18 X 1 GR5
13
10117TK
Shield - Spreader
14
3844
Knob - T, 5/16-18
15
15118
Motor - Spreader 12 VDC CW 2.5"
16
10118
Spinner - Distributor, Spreader
Step 3:
Remove the nuts and snap ring from
the motor and place the Lower Motor
Support Bracket (11) over the Motor (15).
Thread the nuts onto the motor studs and
tighten. Slide the Spinner/Distributor (16)
over the motor shaft and replace roll pin.
the motor and place the Lower Motor
Support Bracket (11) over the Motor (15).
Thread the nuts onto the motor studs and
tighten. Slide the Spinner/Distributor (16)
over the motor shaft and replace roll pin.
Step 4:
Insert the 5/16” Carriage Bolts (12)
into the Lower Motor Bracket (11),
through the Upper Motor Bracket (9),
and through the Spreader Shield (13).
Place the T-Knobs (14) on the bolts (12)
and tighten. (The guide of the
Lower Bracket will slide up
through the slot in the Upper
Bracket).
into the Lower Motor Bracket (11),
through the Upper Motor Bracket (9),
and through the Spreader Shield (13).
Place the T-Knobs (14) on the bolts (12)
and tighten. (The guide of the
Lower Bracket will slide up
through the slot in the Upper
Bracket).
NOTE: To change the radius of
material being spread, simply
loosen the T-Knobs and slide
loosen the T-Knobs and slide
the mechanism up (smaller
radii) or down (larger radii).
radii) or down (larger radii).