Juiceman JM400 Manuel
GETTING TO KNOW YOUR JUICE EXTRACTOR
† . Food pusher cap (Part # 79B)
† . Food pusher (Part # 77B)
† . Feed chute (Part # 768FT)
. Safety locking lever
† . Lid (Part # 768LID)
† 6. Stainless steel mesh filter (not shown) (Part # 769)
† 7. Juice bowl (Part # 770B)
8. Juice spout
† 9. Juice pitcher with froth separator (Part # 77)
0. Base
† . Cleaning brush (Part # 766B)
. Speed control
† . Pulp container (Part # 77)
. Pulp spout
. Pulp opening
Note: † indicates consumer replaceable/removable parts
† . Food pusher (Part # 77B)
† . Feed chute (Part # 768FT)
. Safety locking lever
† . Lid (Part # 768LID)
† 6. Stainless steel mesh filter (not shown) (Part # 769)
† 7. Juice bowl (Part # 770B)
8. Juice spout
† 9. Juice pitcher with froth separator (Part # 77)
0. Base
† . Cleaning brush (Part # 766B)
. Speed control
† . Pulp container (Part # 77)
. Pulp spout
. Pulp opening
Note: † indicates consumer replaceable/removable parts
How to Use
This product is for household use only.
GETTING STARTED
• Remove all packing material, and any stickers from the product.
• Remove and save literature.
• Please go to www.prodprotect.com/applica to register your warranty.
• For additional information about your new juice extractor go to
GETTING STARTED
• Remove all packing material, and any stickers from the product.
• Remove and save literature.
• Please go to www.prodprotect.com/applica to register your warranty.
• For additional information about your new juice extractor go to
www.juiceman.com.
• Your juice extractor is partially assembled in the box.
• Take the appliance apart and wash all removable parts as instructed in CARE
• Take the appliance apart and wash all removable parts as instructed in CARE
AND CLEANING section of this manual. This will remove any traces of dust or
residue left from manufacturing and shipping.
• Place on a dry level counter to prepare to assemble.
ASSEMBLING YOUR JUICE EXTRACTOR
Important: Always make sure your juice extractor is unplugged before starting
ASSEMBLING YOUR JUICE EXTRACTOR
Important: Always make sure your juice extractor is unplugged before starting
to assemble.
1. Place juice bowl over base with juice spout facing
toward the safety locking lever. Lower juice bowl
onto the base so that spout slides through the oval
ring on the base (B).
2. With both hands, hold the filter by the rim and
center it over drive shaft inside the juice bowl.
Carefully lower filter into the juice bowl, rotating
slightly until it drops into place; press down firmly
on the rim to secure (C).
Note: When assembled properly, the filter will spin
freely in the juice bowl. To check that it is assembled
properly, simply try spinning the filter by the rim.
B
C