Honda 08E55-S01-100H Manuel D’Utilisation
2 of 8
AII 20465 (9908)
© 1999 American Honda Motor Co., Inc - All Rights Reserved.
NOTE: The Owner’s Manual included with the Security
Attachment should be placed in the glove box for future
reference. The Owner’s Manual included with the Security
System should be discarded.
Attachment should be placed in the glove box for future
reference. The Owner’s Manual included with the Security
System should be discarded.
1.
Make sure you have the anti-theft code for the radio,
then write down the frequencies for the preset
buttons.
then write down the frequencies for the preset
buttons.
2.
Disconnect the negative cable from the battery.
3.
Check to be sure the switch on the control unit is in
the correct mode for the HX, EX and VP models.
the correct mode for the HX, EX and VP models.
CONTROL UNIT
CX/DX
HX/LX/EX
Tear off
this label.
this label.
3-Pin connector
Nut
Washer
Owner’s Manual
Cushion tape
2 Collars
Flange bolt, 6 x 12 mm
2 Bolts, 4 x 30 mm
Wire tie
4 Short wire ties (white)
INSTALLATION
The knob is set in
this position at the
factory.
this position at the
factory.
Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your car. These procedures should not
be attempted by “do-it-yourselfers.”
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your car. These procedures should not
be attempted by “do-it-yourselfers.”
TOOLS AND SUPPLIES REQUIRED
Phillips screwdriver
Stubby Phillips screwdriver
Drill
Eye protection (face shield, safety goggles, etc.)
5.5 mm and 12 mm Drill bits
Tape measure
10 mm and 12 mm Sockets
Ratchet
7 mm, 10 mm, 12 mm and 17 mm Combination wrenches
Diagonal cutters
Utility knife
Electrical tape
Resistor