High End Systems Technobeam Manuel D’Utilisation
2-2
Powering On the Fixture
Technobeam
®
User Manual
Powering On the Fixture
Do all of the following before powering on the fixture:
1.
Select the correct voltage and frequency settings for the power outlet
you will be using. See the section titled “Setting the Fixture Voltage” on
page 1-10.
you will be using. See the section titled “Setting the Fixture Voltage” on
page 1-10.
2.
Install the appropriate power cord cap as described in the section
titled “Installing the Power Cord Cap” on page 1-7.
titled “Installing the Power Cord Cap” on page 1-7.
3.
Replace the access door shown in Figure 2-2 on page 2-3.
Homing the Fixture
Connect the fixture to an appropriately-rated power outlet; there is no
power switch. You will hear the sounds of the motors and gears as
they home. This is normal.
power switch. You will hear the sounds of the motors and gears as
they home. This is normal.
LED Display
When the fixture has finished homing, the LED display should show the
fixture’s software version, similar to Figure 2-1:
fixture’s software version, similar to Figure 2-1:
Figure 2-1. The initial LED menu display shows the fixture’s software
version.
version.
Note
The LED display will alternate between the version
number (shown above) and the fixture number or DMX
start channel unless an error occurs during start-up.
number (shown above) and the fixture number or DMX
start channel unless an error occurs during start-up.
If the fixture fails to home, or if the menu displays an error message,
see the section titled “Troubleshooting” on page 2-20 now.
see the section titled “Troubleshooting” on page 2-20 now.
R
MENU
ENTER