Hitachi HCX5000I Manuel D’Utilisation
F
IXED
K
EYS
S
ELEC
S
ET
500A U
SER
G
UIDE
1-14
HCXTD840, Issue 1, July 2001
Table 1-1 SelecSet 500A Fixed Keys
Key Name
Function/operation
<ALARM>
The major/minor alarm lights steadily when a system
malfunction is detected. The alarm remains lit until the
problem is corrected.
malfunction is detected. The alarm remains lit until the
problem is corrected.
<NIGHT>
Press <NIGHT> to place the system in night mode
(CAP1-CAP4)
Call appearances are virtual lines that are used to receive/
place/hold calls while call control operations are performed.
CAPs can represent up to four calls, with each CAP
representing one call.
place/hold calls while call control operations are performed.
CAPs can represent up to four calls, with each CAP
representing one call.
<HLD1>-<HLD4> Hold loops are used to place up to four calls on hold, with
each held call represented by a display. (Each hold loop can
be used to place a single call on hold).
be used to place a single call on hold).
<DSPL>
Press <DSPL> to display functions of programmed keys
<CONF>
Press <CONF> to establish a conference call. Press
<JOIN>, dial a station number or outside number and press
<CONF> to establish a three-party conference. Press
<CONF>, dial a number and press <CONF> again to
establish a multiparty conference of up to six parties.
<JOIN>, dial a station number or outside number and press
<CONF> to establish a three-party conference. Press
<CONF>, dial a number and press <CONF> again to
establish a multiparty conference of up to six parties.
<SWAP>
Press <SWAP> to alternate between two sides of a split call.
<START>
Press <START> to originate calls or perform other call
processing functions (like picking up the receiver on other
phones). Gives or cancels dial tone.
processing functions (like picking up the receiver on other
phones). Gives or cancels dial tone.
<CNCL>
Press <CNCL> during call transfer if you misdial a number.
Pressing this key disconnects the last party added to a
conference.
Pressing this key disconnects the last party added to a
conference.
<HOLD>
Press <HOLD> to place an active call on hold.
<JOIN>
Press <JOIN> to transfer a call and return to the idle state.
<ANS>
Press <ANS> to answer all calls that ring at the attendant
position.
position.