Empire Comfort Systems pmn Manuel D’Utilisation

Page 9

15627-4-0806

Attention: Included in the hardware package are (8) 1/4" inside 

diameter washers. A 1/4" washer may be used with a 1/4-20 x 3/8" 

bolt when assembling the stove casting parts. If a bolt hole is not 

tapped deep enough for a tight fit between stove casting parts,  the 

1/4" washer can be used as a shim to provide a tight fit.
The 1/4" washers are not required for assembly of the stove casting 

if all the bolt holes are tapped to a proper depth.
Additonal 1/4" washers are to be purchased locally.
  1.  Place porcelain casting pieces on a non-abrasive surface 

in order to protect the porcelain finish. The exterior of the 

porcelain casting pieces should be facing the non-abrasive 

surface.

  2.  The assembly of the casting is accomplished in 7 stages:

A. Attaching legs to the sides (Figure 6).

B.  Attaching rear cover to sides (Figure 7).

C.  Removing protective packaging from casting front and 

window (Figure 8).

D. Assembly of front by attaching retaining tabs and placing 

front on unit (Figure 9).

E.  Inserting firebox into partially completed assembly (Figure 

10 and Figure 11).

F.  Attaching firebox to rear cover (Figure 12).

G. Placing top on unit.

  3.  Refer to Figure 6, the leg pads will have the letter "A" and 

"B" stamped into the metal. Place leg pad "A" and leg pad 

"B" at the bottom of each casting side. Leg pad "A" attaches 

to the front of the casting side, right and to the rear of the 

casting side, left. Leg pad "B" attaches to the rear of the casting 

side, right and to the front of the casting side, left. Position 

the 3/4" flange on the leg pad against the (2) locator dimples 

on the casting side. The 3/4" flange must be facing upward, 

toward the top louver openings on the casting side. Attach 

the two rear leg pads to the casting sides with (2) 3/8" bolts. 

Attach but do not completely tighten the two front leg pads 

to the casting sides with (2) 3/8" bolts. Attention: The front 

leg pads can be adjusted to provide a snug fit between the 

casting front and the casting sides.

  4.  Attach (4) leveling bolts to the bottom of the (4) legs.

APPLIANCE HARDWARE PACKAGE

ASSEMBLY OF STOVE CASTING

Part

Description

Part 

Number

Quantity 

Supplied

1/42-0 x 1" Phillips Head Bolt

R-3188

4

1/4-20 x 3/8" Phillips Head Bolt

R-3646

16

1/4-20 x 1/2" Leveling Bolt

R-3747

4

No. 10 x 1/2" Hex Washer Head Screw

R-2737

10

1/4-20 Washer Head Nut

R-3185

4

Leg Pad "A" (see Figure 6)

CI-008

2

Leg Pad "B" (see Figure 6)

CI-009

2

1-1/4" x 1/2" Retaining Tab (see Figure 8)

CI-007

4

1/4" x 9/32 Washer (Not Shown)

R-1150

8