Central Hydraulics Musical Table 1100 Lb. Manuel D’Utilisation
SPECIFICATIONS
Capacity:
1100 lbs. Maximum
Maximum Height:
33-1/4”
Table Length:
31-5/8”
Table Width:
19-5/8”
Overall Dimensions:
41” x 19-5/8” x 37-1/2”
Weight:
187 lbs.
Construction:
Overall Steel Construction
Wheels:
Hard Rubber with Ball Bearings
WARNING
1.
Read and understand the instruction manual.
2.
Do not load hydraulic table cart beyond its rated capacity.
3.
Do not allow people to sit or ride on the hydraulic table cart.
4.
Secure load before raising or lowering hydraulic table cart.
5.
Do not transport loads with hydraulic table cart in a raised position.
6.
Use only on smooth surfaces.
7.
Keep hands and feet clear when raising or lowering lift.
8.
Open release valve knob slowly to allow load to descend in a controlled manner.
9.
Failure to comply with the instructions and warnings in this manual may result in
personal injury or property damage.
personal injury or property damage.
10.
Be sure to wear ANSI approved safety goggles when using tools or equipment.
The Warnings, Cautions, and Instructions discussed in this instruction manual cannot cover all
possible conditions and situations that may occur. It must be understood by the operator that
commom sense and caution are factors which cannot be built into this product, but must be supplied
by the operator.
possible conditions and situations that may occur. It must be understood by the operator that
commom sense and caution are factors which cannot be built into this product, but must be supplied
by the operator.
ASSEMBLY
Refer to the Parts Diagram and Parts List on page 3 of this booklet.
1. Attach HANDLE (51) to the FRAME (24) with two PINS (64), and two RETAINERS (63).
2. Tension the SPRING (18) by turning the RELEASE KNOB (17) one full turn counter clockwise and
hold. Fasten two LOWERING RODS (19 and 21) with SET SCREW (20).
3. Attach FOOT LEVER (46) to LEVER BRACKET (45) with HEX CAP BOLT (48), WASHER (49)
and NUT (50).
2. Tension the SPRING (18) by turning the RELEASE KNOB (17) one full turn counter clockwise and
hold. Fasten two LOWERING RODS (19 and 21) with SET SCREW (20).
3. Attach FOOT LEVER (46) to LEVER BRACKET (45) with HEX CAP BOLT (48), WASHER (49)
and NUT (50).
OPERATION
1.
Close release valve by turning clockwise until it stops.
2.
Table is raised by activating the foot pedal.
3.
To lower the table, slowly turn the release knob counter-clockwise.
4.
Before loading, and while stationary, lock the caster brake.
MAINTENANCE
1.
Lubricate each friction point monthly with a good quality grease.
2.
Check the free movement and wear of wheels. Replace if needed.
3.
Check caster brake function. It should lock firmly and release completely.
4.
Check for oil leakage from the hydraulic cylinder. The hydraulic cylinder is not user servicable.
Page 2 SKU # 38074 Rev 01/00
38074 Table Cart Manual.p65
10/30/03, 10:49 AM
2