Symphonic ZEKTOR MAS3 Manuel D’Utilisation

4

PIP

ENT

TV

VCR

CBL /

SAT

DVD RCVR

POWER

VOL

CH

+ +

_ _

Using the MAS3 with a Remote Control

Remote operations of the MAS3 are accomplished through the use of just about any remote control. 

A remote control is not supplied with the MAS3, yet the versatile programming modes of the MAS3 

allows the MAS3 to work with virtually any remote control. The next section "Programming your Re-

mote Control" on page 5, describes how to setup your remote controller. After your remote control 

is programmed the following describes the pre-programmed functions of the MAS3.
There are 9 separate remote controlled commands understood by the MAS3. They are:

• P

.The MAS3 can be toggled from standby to power 

on, and back to standby using a single button of the remote.

• S

. Select input 1. If the MAS3 is in standby mode, it will 

power on and then select input 1.

• S

. Select input 2. If the MAS3 is in standby mode, it will 

power on and then select input 2.

• S

. Select input 3. If the MAS3 is in standby mode, it will 

power on and then select input 3.

• P

. The MAS3 can be set to standby mode by pressing a 

single button of the remote. Once the MAS3 is in standby mode, 

further presses of the P

 button will be ignored. This com-

mand is useful when using the “macro” feature of some program-

mable remote controls, and is used when it is unknown whether the 

MAS3 is already in standby mode or not.

• P

. The MAS3 can be powered on from standby by pressing 

a single button of the remote. Once the MAS3 is power on, further 

presses of the P

 button will be ignored. This command is 

useful when using remote controls that allow “macro” programming, 

where it is unknown whether the MAS3 is already power on or not.

• S

. Toggles through three different bright/dim display 

modes. They are: Bright all the time. Dim all the time. Bright for 4 sec-

onds after any keypress, and then automatically dim.

• S

. Select the next higher input. If input 3 is currently selected, 

then this command will cause input 1 to be selected.

• S

. Select the next lower input. If input 1 is currently selected, 

then this command will cause input 3 to be selected.