Rinnai ES38 (RHFE-1004FTA) Manuel De Montage
10
Rinnai Corporation ES38 Manual
Humidifier and Air Flow Direction
Adjusting Air Flow Direction
The vertical louvers may be adjusted to move the air
flow more to the right or to the left.
flow more to the right or to the left.
Use a screw driver or similar object to bend each
louver to the desired position.
louver to the desired position.
Do not bend repeatedly (no more than 5 times) or else
the louver will break.
the louver will break.
The horizontal louvers (which determines the vertical
air flow direction) are fixed and cannot be adjusted.
air flow direction) are fixed and cannot be adjusted.
CAUTION
Do not adjust the air flow
louvers while warm air is
flowing.
louvers while warm air is
flowing.
Adding Water to the Humidifier
Set Back
This function allows a minimum room temperature to be pre-set, between 38ºF
and 78ºF (in 2ºF increments). This temperature should be set below the room
temperature setting. The default setting is 60ºF. Once the Set back function is
selected the appliance will start heating whenever the room temperature falls
below the selected temperature, regardless of timer or manual settings.
and 78ºF (in 2ºF increments). This temperature should be set below the room
temperature setting. The default setting is 60ºF. Once the Set back function is
selected the appliance will start heating whenever the room temperature falls
below the selected temperature, regardless of timer or manual settings.
Follow these steps to set and operate the Set back feature:
1. Make sure the heater is turned OFF.
2. Press the “Set back” button. The light above the button will come on.
3. Press the up and down buttons to set the minimum temperature.
When the “Set back” indicator is on, frost protection is operating, and will always
prevent the room temperature from falling below the pre-set minimum
temperature (as long as electric power and gas is supplied).
prevent the room temperature from falling below the pre-set minimum
temperature (as long as electric power and gas is supplied).
To turn this feature off, press the “Set back” button.
The unit will retain its ON or OFF setting after a power failure. (Default setting at
the factory is on.)
the factory is on.)
Access Door
Max. Fill Line
Humidifier Tray
Filler Spout
Do not force door open too far.
Close door during operation.
Pull
To fill the tray, open the door as shown in the diagram
and pour water into the tray using the spout built into
the door. The air will be humidified as it passes over
the water in the tray.
and pour water into the tray using the spout built into
the door. The air will be humidified as it passes over
the water in the tray.
During operation a small amount of condensation is
produced in the flue system and drains into the
humidifier tray.
produced in the flue system and drains into the
humidifier tray.
If the water overflows from the water level hole, then
do not add any more water.
do not add any more water.
CAUTION
Do not fill the tray while the
appliance is in operation.
Close the door after filling.
The humidifier tray and
surrounding area are hot
when the appliance is on.
appliance is in operation.
Close the door after filling.
The humidifier tray and
surrounding area are hot
when the appliance is on.
Set back
AM
P
M
Set
Room
Temp
Time