Panasonic Attune II Mode D’Emploi
10
Battery loading & replacement
p Refer to operating instructions included with the battery and battery charger.
p Be sure to prepare a fully charged battery.
p The power indicator of this product turns red, the voice message “Battery Low” is heard from the headset, and then a beep
is heard at 5 seconds intervals. It is recommended to replace the battery once this state is reached.
Notes
wInstallation
Insert the battery in the battery case as shown in the figure to the right.
p When inserting the battery, make sure that the terminals
are correctly directed.
Note
wLoading
Install the battery by following steps to
in the figure on the right.
in the figure on the right.
Insert the battery until the lock clicks.
wReplacement
Remove the battery by following steps to
in the figure on the right.
in the figure on the right.
Battery Case
Battery
Terminals
Battery Case
Battery Lock