Overland Storage ARCvault 48 Manuel D’Utilisation

©2007 Overland Storage, Inc.

W

Tape cartridges are loaded using the tape magazines 
provided. The ARCvault 48 has four magazines, two on 
each side. As a safety feature, the magazine doors must be 
shut before the internal robotics can function.

There are two ways to interface with an ARCvault unit— 
the Operator Control Panel (OCP) touch screen on the 
front panel (

) or Remote Management Utility 

(RMU) accessed via a web browser using the default IP 
address of 10.0.0.1. 

All cabling and power connections, along with the unit’s 
power switch, are located on the rear panel (

). On 

a SCSI configuration, the top two SCSI ports connect to 
Drive 1 and the bottom two ports connect to Drive 2. 

Access to the tape drive bay is available through the tape 
drive cover assemblies. Connections are available for 
Ethernet and serial cabling. All unit cooling exhaust is 
handled through the rear panel.

You are ready to connect the unit to your host system. For 
additional information, see the ARCvault 48 User Guide.

The default SCSI configuration is two half-height drives.

1. Connect the LVD SCSI cable to the top SCSI port and 

the other end to your system.

2. Attach the SCSI jumper cable between the second 

and third ports (Drives 1 and 2).

3. Attach the SCSI terminator to the fourth SCSI port.

A

RC

-0

03

7

Retaining Thumbscrews

Operator Control Panel

Tape Cartridge Magazines 

Open Door

Door Handle

Ventilation Slots

A

R

C

-0

00

9

SCSI Ports

AC Receptacle

Ethernet Port

Serial Port

Power Switch

Thumbscrews

System Exhaust Fan

Tape Drive Cover

Lower Drive Bay Cover