Smart Inventions HAWM-UX/UF Manuel D’Utilisation

CHAPTER 2 – CABLING AN 885ix SYSTEM TO A HAWM-UX/UF

 

Connecting the SMART UX60 projector’s ECP harness cable

The ECP harness cable controls all signals and commands sent between the ECP 
and the projector. To install your ECP, follow the instructions in the SMART Board 
X885ix Interactive Whiteboard System Installation Instructions (

).

1. Attach the SMART UX60 projector’s ECP harness cable to the projector by 

attaching the 4-pin power mini-DIN connector and the 7-pin mini-DIN connector to 
the projector’s connection panel, and the DB9 to the control port, as listed on the 
projector connection panel (see page 8).

2. Place the harness cable through the 

cable management clip located 
under the projector. Make sure the 
harness cable’s strain relief sits 
above the clip point. 

IMPORTANT
To add slack to the cable, move 
the cable to the clip’s 
foam-padded section, increase 
the length of cable between the 
clip and the projector and close 
the clip.

3. Connect cables from the projector 

to the interactive whiteboard, 
making sure that all cables pass 
between the two interactive 
whiteboard wall-mounting 
brackets. Once the cables are 
through the brackets, place the 
harness cable toward the left side 
of the interactive whiteboard for 
proximity to the left-mounted ECP.  

4. Place the harness cable through 

the upper cable clips on the side of 
the HAWM-UX/UF. 

5. Connect the harness 11-pin 

cable’s flat connector plug to the 
ECP’s DB15 connector (see page 9).

RCA