Smart Inventions HAWM-UX/UF Manuel D’Utilisation

CHAPTER 3 – CABLING AN 880i4 OR 885i4 SYSTEM TO A HAWM-UX/UF

 

Placing cables for HAWM-UX/UF-mounted 
components

To prevent cable friction, SMART recommends that you first place the cables that 
don’t shift after they’re installed. Cables that connect components mounted to the 
HAWM-UX/UF don’t shift after they’re installed. To prevent cable friction, SMART 
recommends that you place these cables first. 

Using the SMART UF65 and SMART UF65W projector 
connection panel for HAWM-UX/UF mounted components

The following diagram and list identify the SMART UF65 and SMART UF65w projector 
connections to HAWM-UX/UF-mounted components. 

To access the projector connection panel and wire management clip, remove the 
input/output cover on the left side of the projector and remove the cable covers. For 
more information, see the SMART Board X800i4 Interactive Whiteboard System 
Configuration and User’s Guide (

).  

1

4-pin power mini-DIN 5V/2A connector (reserved for ECP harness cable)

2

7-pin mini-DIN connector (reserved for ECP harness cable)

3

RCA jack composite video input (reserved for RCA pod)

4

RCA jack audio left/right input (reserved for RCA pod)

5

Audio 1 and Audio 2 (reserved for audio cable from pen tray)

6

3.5 mm audio output connector (recommended for SBA-L speakers) 

7

DB9 control (reserved for ECP harness)

1

2

3

6

4

7

5