Smart Inventions HAWM-UX/UF Manuel D’Utilisation

CHAPTER 4 – CABLING A 685ix OR D685ix SYSTEM TO A HAWM-UX/UF

 

Connecting your SMART UX60 projector’s ECP harness 
cable

The ECP harness cable controls all signals and commands sent between the ECP 
and the projector. Choose a side of the interactive whiteboard to install your ECP on, 
and then follow the instructions in the SMART Board 685ix and D685ix Interactive 
Whiteboard System Installation Instructions (

1. Attach the SMART UX60 projector’s ECP harness cable to the projector by 

attaching the composite video RCA jack, its associated dual channel audio input 
(two RCA jacks), the 4-pin power mini-DIN connector and the 7-pin mini-DIN 
connector to the projector’s connection panel, as listed on the projector 
connection panel (see page 38). 

2. Place the harness cable 

through the cable 
management clip located 
under the projector. Make 
sure the harness cable’s 
strain relief sits above the 
clip point. 

IMPORTANT
To add slack to the 
cable, move the cable 
to the clip’s 
foam-padded section, 
increase the length of 
cable between the clip 
and the projector and 
close the clip. 

2

USB A jack (recommended location for interactive whiteboard USB 
cable)

3

DB15 ECP connector (reserved for ECP harness cable)