Smithco Paint Sprayer 3007 Manuel D’Utilisation

Operation

PROGRAMMING THE 844 SPRAYER CONTROL SYSTEM 

NOZZLE SELECTION

Default = Red or 0.40 GPM

1. While in the nozzle selection step, the display will remain the same as above except the

!

symbol will

be flashing at the bottom of the display just above a color coded strip.

2. Select the representative color to match the spray tips being used to apply the desired application rate.

Use the 

 or 

 keys to toggle the 

!

 

key through the tabbed color strip at the bottom of the

display panel. The corresponding flow rate for each color will be displayed in Gallons Per Minute at 40 psi

at the lower right of the display. If the programmable tip is the used, toggle the 

!

 

key to the 

 tab.

Flow rates will always be displayed in Gallons Per Minute at 40 psi regardless of any changes to other
display parameters.

3. The table below  indicates flow rates in Gallons Per Minute at 40 psi for the TeeJet VisiFlo color coded

spray tips represented in the 844 Spray Control.

4.

Feature: Based on the tip programmed and nozzle spacing, the 844 console will

calculate the required speed to achieve the application rate that was entered in the last programming
step. The speed will be displayed in the lower left corner of the display window. Keep in mind that this
speed is based on a spraying pressure of 40 psi. More calculations can be performed in the next pro-
gramming step.

5. When the correct flow rate for the spray tips being used has been entered, depress the 

 key to

accept the value and advance to the next step.